V 09/18
OptiStar CG06 Automatic gun control unit Additional functions • 39
The keyboard lock is activated and deactivated by pressing and holding
key T9 (SELECT) and then key T11, the LED L11 (REMOTE) flashes.
The keyboard lock status remains stored, when switching the equipment
off and on. If a memory reset takes place, the keyboard lock will be can-
celled.
On the OptiStar CG06 Automatic gun control unit (automatic device), an
external interlocking by remote input can also be utilized. These two lock-
ing features are independent, which means, if the local interlocking is de-
activated, the external interlocking remains activated and vice versa.
Operation with other guns
Configuration of the Tribo gun
The Tribo gun can be configured by holding the keys T7 and T8 when
switching on. The selected adjustment remains stored, when the device
is switched off. To deactivate the Tribo gun, repeat the steps above.
Operation of the Tribo gun without adapter
For continuous operation, the Tribo gun can be operated without corre-
sponding adapter to the OptiStar CG06 Automatic gun control unit (au-
tomatic and manual equipment). Therefore, the wiring in the Tribo gun
plug must be changed. Move the wire from Pin 5 to Pin 1.
ATTENTION:
This activity must be absolutely carried out by a specialist! Inap-
propriate operation can lead to damage to the control unit! Gema
Switzerland GmbH is in no way responsible for any resulting dam-
ages!
NOTE:
The EasySelect (GM01) manual powder gun cannot be controlled by
OptiStar control units!
To Next Page
Loading...
