V 09/18
58 • Troubleshooting OptiStar CG06 Automatic gun control unit
Replace the front plate
1. Loosen the screws on the front side of the enclosure
2. Disconnect all plugs from the front plate
3. Replace the front plate
4. Reassemble the front plate and the control unit in reverse or-
der as described and install it
NOTE:
The motor plugs are to be put in according to the annotation!
5. Reconnect the mains cable
NOTE:
If there are any problems or uncertainties, please contact a Gema
service center!
OptiStar CG06 - main board configuration
Valve
Power input
Gun
Empty
CAN bus (option)
Power pack
Input (AC)
Power pack
Output (DC)
DigitalBus (option)
FlowControl (option)
Conveying
air
Supple-
mentary
air
Rinsing
ai
Shaping
air
To Next Page
Loading...
