This event is TRUE, if the remaining time is reached or rather undershot.
That means the autonomy time is only available for seconds, the UPS
shutdown is pending.
UPS service is started into the CS121. This event is always true, if the CS121
is running and therefore ideal for permanent recurrent jobs suitable like the
forwarding of emails always after restart of the UPS or to produce log file
entries steady.
UPS RS232 communication lost, CS121 tries to restore the connection.
UPS RS232 communication restored
UPS batteries too old, call UPS service
UPS overload, reduce load otherwise the UPS shutdown is pending
Overtemperature of the UPS
Temperature of the UPS is back in normal range
The autonomy of the battery has reached the defined threshold "Battery
Low". The UPS shutdown is pending. ADVICE: The RCCMD shutdowns will
be set into this event too, but without delay! (Emergency shutdown, if
batteries are to weak)
This event got no relevance and will be removed in the future CS121
firmware
Input bad, alarm will be triggered with the powerfail event
An alarm has occured. Alarm LED at the UPS is flashing
No more alarm is active. Alarm LED at the UPS is off
To Next Page
Loading...
