28
FT
A
S
OTL
A
S
SET RESERVE TIME (NDL/OTL) ALARM
Factory set for 0:05 (hr:min), the Alarm can be set to values between 0:01 and 0:30 (hr:min).
• While viewing the Set 1 screen, press/release the A (left) button 8 times (< 2 sec each time),
the Set Reserve Time Alarm screen appears with the Set Point flashing (Fig. 21).
• Press/release the S (right) button repeatedly (< 2 sec each time) to increase the Set Point
from 0:01 (hr:min) up to 0:30 (hr:min) in increments of 0:01 (hr:min); or depress/hold the S
button to scroll upward through the Set Points at a rate of 8 per second.
• Press/release the A button (< 2 sec) to accept the setting and revert to the Surface Main.
SET 2
These settings are ones that are not likely to change. To save time at the dive site, verify the set
points and adjust them as desired prior to departing on the day's dive trip.
SET UNITS
Factory set for Imperial, Units of Measure can also be set for Metric.
• While viewing the Set 2 screen, press/release the A (left) button momentarily (< 2 sec), re-
lease when the Set Units screen appears with the Set Point flashing (Fig. 22).
• Press/release the S (right) button momentarily (< 2 sec each time) to toggle the Set Point
between Imperial and Metric.
• Press the A button momentarily (< 2 sec) to accept the setting and access Set Date Format.
• Depress both buttons for 2 seconds to revert to the Surface Main.
Fig. 21 - Set Reserve Time
Fig. 22 - Set Units
To Next Page
Loading...
Need help?
General
