Genesis React Pro - Surface Interval and Transition Period

44
PM
PM
A
S
NITROXNITROX
NITROX
SURFACE MODE
When you ascend to 2 FT (0.6 M), the ReACT Pro will enter Surface Mode and begin counting
your Surface Interval.
TRANSITION PERIOD
The first 10 minutes is, in affect, a Transition Period during which time the following information
is displayed top to bottom (Fig. 41):
• Surface Interval (hr:min with colon flashing)
• Wave icon flashing to indicate Surface Mode
• AIR (or NITROX) operating mode icon
• Date as Month_Day (or Day_Month)
• Time of Day (hr:min) with AM (or PM) icon, no icon if set for 24 Hour Format
• NiBG
> Press/release the A (left) button to view the Surface ALT (Temp, O2SAT, Elev).
> Press/release the A (left) button again to view that dive's Log Preview screen, then-
> press/release the S (right) button to view the Log 2 screen
> press/release the S (right) button again to view the Log 3 screen
• Operation will revert to the Surface Main after 2 minutes or if both buttons are depressed si-
multaneously for 2 seconds.
If you descend during the 10 minute Transition Period, time underwater will be considered a con-
tinuation of that dive. Time at the surface (< 10 min) will not be added as Bottom Time.
NOTE: Data will not be stored in the unit's memory until the Transition
Period is completed. Also, no other modes are accessible.
Fig. 40 - Transition Period
N