32
• Press/release the S (right) button (< 2 sec) to toggle the Set Point between ON and OFF.
• Press/release the A button (< 2 sec) to accept the setting and access Set Deep Stop.
• Depress both buttons for 2 seconds to revert to the Surface Main.
SET DEEP STOP (DS)
Deep Stop (described in more detail later in the No Deco Dive Mode section) is a completely op-
tional safety stop that, when set ON, will trigger upon descent past 80 FT (24 M) and display a
recommended Stop to be taken at 1/2 the calculated Max Depth of that dive.
Factory set OFF, the Deep Stop feature can also be set for ON. When set OFF, the associated
screens will not be displayed during dives.
• While viewing the Set 2 screen, press/release the A (left) button 11 times (< 2 sec each
time), the Set DS screen appears with the Set Point flashing (Fig. 29).
• Press/release the S (right) button (< 2 sec) to toggle the Set Point between ON and OFF.
• Press/release the A button (< 2 sec) to accept the setting and revert to the Surface Main.
STOP
A
S
Fig. 29 - Set Deep Stop
To Next Page
Loading...
Need help?
General
