GeoVision GV-IPCamera Series User Manual

120
12.4.2 Power Connection
There are two ways to supply power to the camera:
 Use a Power over Ethernet (PoE) adapter to connect the camera to
the network, and the power will be provided at the same time.
 Plug the power adaptor to the terminal block as shown below. The
power adapter is an optional device. For detail, see Options in the
GV-IPCAM Hardware Manual for Target Bullet Camera on the
Software DVD.
1. Insert the black wire of the data cable to the left pin (-) and the red
wire to the right pin (+).
2. Connect the DC 12V power adapter to the terminal block.
DC 12V Power Adaptor
Terminal Block

GeoVision GV-IPCamera Series Specifications

General

Brand	GeoVision
Model	GV-IPCamera Series
Category	Security Camera
Language	English