212
20.3 Installation
Follow the steps below to install, connect to and adjust your Cube Camera.
1. Put the supporting rack on the desired location and make marks for
screw anchors.
2. Drill the marks and insert the screw anchors.
3. Secure the supporting rack onto the wall using the supplied screws.
4. Screw the camera onto the supporting rack and fasten the indicated
screw.
5. Connect the network and power cables to the camera. See 20.4
Connecting the Camera in the Quick Start Guide.
6. Access the live view. See 24.2 Assigning the Live View in the Quick
Start Guide.
To Next Page
Loading...
Need help?
General
