Gerber EDGE FX - Page 18

12
CHAPTER 2
Installing the GERBER EDGE FX
2 Press F4, SYSTEM to display the SYSYEM MENU.
SYSTEM MENU
F1 NETWORK CANCEL F3
F2 DIAG MOTION F4
3 Press F1, NETWORK to display the NETWORK MENU.
NETWORK MENU
F1 TCP/IP CANCEL F3
F2 ETHERNET F4
4 Press F1, TCP/IP to display the TCP/IP MENU where you can change the IP Address
of the GERBER EDGE FX.
TCP/IP MENU
F1 IP ADDR. CANCEL F3
F2 SUBNET MASK DHCP F4
5 Press F1, IP ADDR. to open the IP ADDRESS MENU where you change the IP address.
The
––– designates which octet (three digit section of the address ranging from 000 to
255) is available to be changed. Use F4, NEXT to move the active designation to the
octet that you wish to update.
IP ADDRESS MENU
F1 SAVE CANCEL F3
F2 ––– NEXT F4
169 . 254 . 128 . 129
6 Use the Left or Right Slew keys to change the value of the octet. Press F4, NEXT to
move the active designation to the next octet and change that value. Continue until the
entire IP Address is updated.
Note: This procedure uses the default IP address of the GERBER EDGE FX as an example.
Your IP address for the printer may be different.
7 Press F1, SAVE to set the displayed IP Address. The display changes to:
IP Address used
after reboot.
Continue with step 8. The address will be active after cycling the printer
power at the end of the procedure.
8 Press F3, CANCEL to leave the IP Address Menu and return to the SYSTEM MENU.