Gerber EDGE FX - Setting the IP Address and Network Mask of Your Computer for Direct Connection

To Next Page

To Previous Page

9 Press F1, NETWORK to display the NETWORK MENU.

NETWORK MENU

F1 TCP/IP CANCEL F3

F2 ETHERNET F4

10 Press F1, TCP/IP to display the TCP/IP MENU where you can change the Subnet

Mask of the GERBER EDGE FX.

TCP/IP MENU

F1 IP ADDR. CANCEL F3

F2 SUBNET MASK DHCP F4

11 Press F2, SUBNET MASK to open the SUBNET MASK MENU where you can change

the Subnet mask of the printer. The

––– designates which octet is available to be

changed. Use F4, NEXT to move the active designation to the octet you wish to update.

SUBNET MASK MENU

F1 SAVE CANCEL F3

F2 ––– NEXT F4

255 . 255 . 000 . 000

12 Use the Left or Right Slew keys to change the value of the octet. Press F4, NEXT to

move the active designation to the next octet and change that value. Continue until the

entire Subnet Mask is updated.

13 Press F1, SAVE to set the displayed Subnet Mask. The display changes to:

Subnet Mask

used after reboot.

14 Press F3, CANCEL to exit the menu and return to the MAIN MENU.

15 Cycle the power to the GERBER EDGE FX. The network address will be active after

cycling the printer power.

Setting the IP Address and Network Mask of your computer for direct

connection

If you need to change the network address of you computer that is directly connected to the

GERBER EDGE FX, follow the procedure for your Windows operating system (Windows 98 SE

(with Internet Explorer 5.5 or higher), Windows XP, or Windows 2000). These procedures use

the following address for the computer:

♦ Computer IP address: 169.254.128.130

♦ Computer Network Mask: 255.255.0.0

Other manuals for Gerber EDGE FX