Gerber EDGE FX - Page 20

14
CHAPTER 2
Installing the GERBER EDGE FX
To set the IP Address and Network Mask for Windows 98 SE with IE 5.5 or higher
1 Click Start > Settings > Control Panel.
2 Double-click the Network icon.
3 Click the Configuration tab.
4 Click TCP/IP.
5 Click Properties to open the TCP/IP Properties dialog box.
Note: Depending on your setup, your computer's IP address may vary.
6 On the IP Address tab, click Specify an IP Address:
7 Enter 169.254.128.130 for the IP Address.
8 Enter 255.255.000.000 for Network Mask.
9 Do not enter a Gateway address; it is not required for direct connection.
10 Click OK to close the TCP/IP Properties dialog box.
11 Click OK to close the Network dialog box.