89
Replacing the bail arm material squeegees
Replace a bail arm material squeegee immediately if it is bent or damaged. Even if the
squeegees are undamaged you should replace them once a year. Remove the two material
squeegees by peeling them off the bail arms and discarding them. Clean any residual adhesive
off the bail arms with a lint-free cloth moistened with 99% isopropyl alcohol. Let the bail arms
air dry.
Remove the adhesive liner off a new material squeegee and press it firmly into position. Repeat
with the remaining squeegee. One set of replacement materials squeegees is included in the
accessories box. Additional squeegees can be obtained from Gerber Customer Service.
Foil squeegee
Four screws
Material
squeegees
To Next Page
Loading...
