Gerber EDGE FX - Updating the GERBER EDGE FX firmware

55
Choosing the numeric units
The units used on the GERBER EDGE FX and on the web pages can be chosen via the System
Settings page of the web interface. The choices are: Inches, Feet, Yards, Centimeters, and Meters.
The default numeric unit is Inches.
To choose the numeric unit
1 Open the GERBER EDGE FX web interface by entering the printer's IP address in the
Location or Address line of your web browser (for example: http://169.254.128.129).
The Welcome to GERBER EDGE FX screen displays.
2 Click the System Settings link to open the System Settings page.
3 Choose a numeric unit from the drop down menu.
4 Click Change Settings to apply the new units to the GERBER EDGE FX.