23
3 Press F1, NETWORK to display the NETWORK MENU.
NETWORK MENU
F1 TCP/IP CANCEL F3
F2 ETHERNET F4
4 Press F1, TCP/IP to open the TCP/IP MENU.
TCP/IP MENU
F1 IP ADDRESS CANCEL F3
F2 SUBNET MASK DHCP F4
5 Press F4, DHCP to open the DHCP menu.
DHCP MENU
F1 ENABLE CANCEL F3
F2 DISABLE F4
Currently Disabled.
6 Press F1, Enable to activate DHCP. The new setting will be in effect after cycling the
power to the printer. The system displays the following message:
F1 DHCP enabled after F3
F2 reboot. F4
7 Cycle the printer power to change the DHCP setting.
Note: If you have enabled DHCP and the server successfully assigns an IP address, you will no
longer be able to assign a static network address in the IP Address menu. If you return to the
IP Address menu the --- symbol that designates the ability to change the address no longer
appears. The lack of the --- symbol indicates that DHCP is enabled. You can disable DHCP if
you later need to use a static IP address.
To Next Page
Loading...
