Help in case of malfunctions
10 / 910
Trouble: Cause: Remedy: Page:
Stripping unit
Header stops during the harvest
Sluggishness Stubble cutter
knife distance too great
10/000
Stubble cutter cutting edge round Parts to replace 10/000
Working speed too high To adapt
Rotors are blocked
Stripper Stripper to adjust 10/000
Rotor knife screws too long Original screw to mount 10/000
Cutting disks worn Cutting disks to change 10/100
Slipping clutch of the row unit does
not react
Foreign bodies Foreign bodies to remove,
wearing to check
09/800
Overload Working speed to reduce
and/or speed to increase
09/440
Straw portion too high
Stripping plates Stripping plates to open as
far as possible
09/480
Working speed Working speed to adapt to
the conditions
Cloggings within the row unit
Parallelism of stripping plates wrong
Stripping plates to adjust 09/480
Gathering chains slip Chains to replace or shorten
09/520
Foreign bodies in or beneath the row
unit
To remove, dragging maize
chaff to remove
Speed too low Check via monitor 09/440
Cut-off block Missing or defective 10/210
Maize cob losses
Speed too high To reduce, if required 09/440
Shield extension rubber Missing or defective 10/500
Cob saver To mount in addition 10/500
Working speed Considerably to increase 09/360
Outer bodywork Increases to mount
Row distance Machine to adapt to the
conditions
09/000
Corn losses
Stripping plates To adjust narrower 09/480
Speed To reduce, if required 09/440
Refeeding from
gathering channel conveying chain
Abdeckung oberhalb der
Querförderschnecke
niedriger einstellen
09/760
Combine
manual
Working speed To increase until header is
better filled with material.
To Next Page
Loading...