ProfiLux 4 Resource Guide
EN 2018-13-11 53
When connecting GHL Powerbars, at least 1 Powerbar should be connected
directly to the PAB-port on the back of the P4 or an Expansion Box 2.
You can view our “How to add a PAB-device“ how-to video by clicking the
link below.
How to add a PAB-device to the P4:
https://youtu.be/dT9_JfY3qH8
OPTIONAL: Assign PAB devices directly on the P4
Instead of assigning PAB devices using GHL Control Center, as an alternative
you can also do the assignment by using the on-board P4 touch keys.
Here is how to do this:
1. Connect PAB devices to P4 and power ON (if applicable).
2. Press up or down arrow key, select SYSTEM
3. Select CONFIGURE PAB, select ASSIGN DEVICES
4. Press
right
(>)
arrow to select devices, then select the check mark
To add a new PAB-device to your ProfiLux 4, please follow these steps:
1. Take a PAB-cable and connect one-end of the cable to the new PAB-device and the
other-end to an available PAB-port of another PAB-device. For example, connect the PAB
cable to the back of the P4 and other end of the cable to the PAB-port on the
Powerbar5.1.
2. Connect to the ProfiLux 4 using GHL Control Center and click on SYSTEM.
3. Click on ASSIGN DEVICES; a new window will pop up.
4. Select the devices you wish to assign, then click OK.
To Next Page
Loading...
Need help?
General
