To Next Page

To Previous Page

ProfiLux 4 Resource Guide

EN 2018-13-11 97

Using a Float or Optical sensor for a return pump?

If you‘ll be using this leak detection feature for the purpose of shutting down

your return pump if sump water level gets too low, you MUST invert the

reaction of the sensor. On the LEVEL settings page, simply select the sensor

you’re using for this function and select YES to invert the reaction.

ASSIGNING THE FUNCTION

1. Click on the (+) icon to the left of

System.

2. Select SWITCH CHANNELS AND OUTLETS.

3. Select the Powerbar outlets that you’d like to react to this Leakage detection function.

4. Set the function to FILL WATER and select the

Control circuit

number you used when

you created the Leakage detection function.

 For example, if you created the function on Control circuit 2, set the function to

FILL WATER 2. If Control circuit 3 was used, set the function to FILL WATER 3.

5. Type-in a description in both fields, set a black-out delay if necessary, and then click OK.

6. Repeat Step 3 as necessary.

7. Click SAVE CHANGES.

NOTE

By default, the assigned sockets will stay ON with this function. When a

sensor detects a leak or a sensor is triggered, the assigned socket will turn

OFF until the alarm is reset or problem is solved.

For those using a float or optical sensor for their return pumps, since the

sensor reaction is inverted, the socket will stay ON when the sensor is in the

water. The socket will turn OFF when it is no longer in the water.

Other manuals for GHL ProfiLux 4

Questions and Answers:

Need help?

Do you have a question about the GHL ProfiLux 4 and is the answer not in the manual?

General