GRAPHTEC CE6000 SERIES - Page 157

CE6000-UM-251-9370 9-14
9 TROUBLESHOOTING
Symptom Conrmation Items Cause Solution
The Y Position Alarm is
displayed after the power
is turned on. And this
occurred after the main
board was replaced.
For the CE6000-40/60:
The carriage hit the
left side plate after the
two push rollers are
detected.
The dip-switch of the
main board was setting
to the wrong setting.
Perform the NV-RAM
clear correctly, and
then set the dip-switch
correctly.
For the CE6000-120:
The carriage hit the
left side plate after the
three push rollers are
detected.
The number of push
rollers are three.
The sufx setting is
wrong.
The sufx setting is set
to the AMO.
The number of push
rollers are setting to the
four for the three push
rollers model.
Set the sufx to the
“STD”.
And set the number of
push rollers settings to
the three.
The Y Position Alarm is
displayed during cutting.
The home sensor
function is setting
disabled.
The pen block hits the
left side plate, and then
it displays Y Position
Alarm.
Set the home sensor
function to Enabled.
How long was this plotter
used?
The Y motor is defective
if this plotter was used
long time.
Replace the Y motor.
The fourth push roller is not
detected for the CE6000-
120AMO. And this occurred
after the main board was
replaced.
Conrm the sufx setting
or the number of push
rollers.
The sufx setting
settings was setting to
wrong.
Set the sufx settings to
“AMO”.
The fourth push roller is not
detected for the CE6000-
120. And this occurred
after the main board was
replaced.
Conrm the number of
push rollers settings.
The number of push
roller settings was
setting to wrong.
Set the number of push
rollers to the four.
The “E05004 ERROR
REALIGN ROLLERS” is
displayed.
Conrm the push roller
is set to the correct
position.
The push roller is not set
to the correct position.
Set the push roller to the
correct position.