SK200-UM-251-9370 5-13
5. DAILY MAINTENANCE
(10) The following prompt is displayed. Insert the color correction sheet into the scanner as instructed.
Position the color correction sheet so that the red bar in the center of the sheet is centered in the scanner (but with
the printed side down).
(11) Click the [OK] button to start scanning.
After scanning has been completed, an enlarged view of the color-corrected data is displayed.
(12) Click the Fit icon to display the entire image, and check whether there is any discrepancy in color. If
there is no discrepancy, color correction is complete. Click the [Close] button.
If there is still some color discrepancy after performing Color Correction:
• Repeat the Color Correction procedure.
• Perform the Calibration procedure, and then repeat the Color Correction procedure.
If you perform the color correction procedure several times with no discernible results, there may be a problem
with the scanner itself. In this case, please contact the store where you purchased your scanner or your nearest
Graphtec representative.
To Next Page
Loading...
