SK200-UM-251-9370 9-13
9. ADJUSTMENTS USING THE SOFTWARE
(6) Check the scanning point of the top center circle.
(7) Zoom in to the top center circle using the zoom button.
If the start point of the scanning is within the top center circle as shown below, it does not require offset
adjustment.
(8) If the starting point of the scanning is outside of the top center circle, click the Origin box and then input
"0".
0
(9) Click the "Check" button, then click the "Set" button. The following dialog box will appear.
Click the "OK" button.
(10) Scan the offset target chart again.
(11) Zoom in to the top center circle using the zoom button.
To Next Page
Loading...
