SK200-UM-251-9370 9-14
9. ADJUSTMENTS USING THE SOFTWARE
(12) Click anywhere within the Origin box. The crosshairs cursor appears in the Scanner Adjustment window.
0
(13) When the crosshairs cursor appears in the Scanner Adjustment window, click on the center of the top
center circle with the crosshairs cursor.
(14) Click the "Check" button, then click the "Set" button. The following dialog box will appear.
Click the "OK" button.
(15) Scan the offset target chart again.
Confirm that the starting point of the scanning is within the top center circle as shown below.
To Next Page
Loading...
