Guldmann GH2 - Replacement of Strap

© Guldmann GB-1394/11/08
99
7. servIce
GH2 – Replacement of strap
Unplug the lifting motor
(and drive motor if installed)
Pull the wires of lifting motor
(and drive motor if installed)
out of the wire groove
Demounting of bracket for the printed circuit board
To release the bracket for the printed circuit board, pull the
front hook outwards as shown in the illustration.
Then pull the bracket towards the front hook and outwards
in order to disengage the hooks at the end of the bracket.
GH2 Service manual