PEL-2000 Series User Manual
110
Editing CR Static Parameters ............. 132
Select CV Mode .................................. 134
Editing CV Parameters ....................... 135
Select CV Response Speed ................. 137
Creating a Program Sequence ............ 138
Program Chains ................................. 143
Running a Program ............................ 145
Edit Sequence .................................... 151
Create Sequence Loop ........................ 153
Channel Duration Time Settings ........ 155
Run Sequence .................................... 157
Channel Configuration ................................................... 160
Accessing the Configuration Menu ..... 161
Setting (OCP/OVP/OPP/UVP) ........... 162
Protection Clear ................................. 165
Setting the CC Voltage Range ............. 165
Adjusting the Von Voltage and Latch .. 167
Configuring the Short key ................... 168
Configuring Channel Control .............. 170
Configuring the Independent Setting . 171
Configuring the Load Delay Time ....... 173
Configuring Step Resolution .............. 175
Go/NoGo ........................................... 177
Mainframe Configuration ............................................... 180
Accessing System Information ........... 181
Accessing the Load Menu .................. 182
Configuring the Date and Time .......... 183
Adjusting the Speaker ........................ 184
Adjusting the display settings ............ 185
Adjusting the Frame Control .............. 187
To Next Page
Loading...
