GW Instek PEL-2004 - GPIB Installation

PEL-2000 Series User Manual
38
GPIB Installation
WARNING
To avoid static electricity, please use appropriate anti-
static work practices.
GPIB Card
installation
The PEL-2004 and 2002 has GPIB as an option (GW
Instek part no. PEL-001).
Steps
1. Ensure the mainframe is disconnected from
mains power.
2. Remove the screws from the GPIB cover plate
and remove the cover plate from the rear panel.
3. Slide the GPIB card into the slot and push
gently until the back plate is flush with the rear
panel.
1
2
4. Use the screws that were removed from step 1
to secure the GPIB card.