GW Instek PEL-2004 - Interface Configuration; Configure RS-232 C Interface

INTERFACE
233
Interface Configuration
Configure RS-232C interface
RS-232C
configuration
Connector
DB-9, Male
Baud rate
9600
Parity
None
Data bit
8
Stop bit
1
Connect the RS-232C cable
(GW Instek part no. GTL-232)
to the rear panel port: DB-9
male connector.
Pin assignment
15
69
2: RxD (Receive data)
3: TxD (Transmit data)
5: GND
1, 4, 6,7, 8, 9: No connection
PC connection
Use the Null Modem connection as shown in the
diagram below.
Pin 2 RxD
Pin 3 TxD
Pin 5 GND
Pin 2 RxD
Pin 3 TxD
Pin 5 GND
PEL series PC