GW Instek PEL-2004 - Create Sequence Loop

OPERATION
153
Note
The Point number can only be changed if more points
have already been added.
Save Sequence
11. Press Save (F3) to save the
sequence.
Note
The save icon will only appear after a change has been
made in the menu.
Create Sequence Loop
Background
Sequences can be looped a number of times. The
loops can be started at any point in the sequence.
The Start of Loop function determines which point
will start each repeating loop.
The On End Load function will set the load to on
or off at the end of a sequence until the end of the
last sequence.
CC Vrange sets the range in CC mode for
Sequences.
See page 74 for more details.
Ensure the menu is in the Seq. Edit menu and that
a sequence has been created. See page 151
Parameters
Repeat 1~9999/0=Infinite
Start of Loop
001~ last point
On End Load
OFF / ON
CC Vrange
Hi
g
h/Low
Panel operation
1. Press Loop (F4) to enter the Loop
menu.