GW Instek PEL-2004 - Select CR Dynamic Mode

OPERATION
129
Panel Operation
1. Press the F2 (Range) key
repeatedly until High or Low
range is selected.
Range
High
Range
Low
The range will be reflected in both
the bottom menu system and the
Current Operation Channel Status
panel.
CR
Dyna
Low
CH1
Main
Low range Low
High range High
Note
Changing the range will only affect the current (active)
channel. Other channels will not be affected by any
changes.
All resistance values and slew rates are dependent on
Range, i.e., A Value in low range can be different from
A Value in high range.
Select CR Dynamic Mode
Background
Constant Resistance mode can be set to dynamic or
static mode. Dynamic mode is used to
automatically set varying load rates.
Ensure the menu is in CR Mode. See page 128.