OPERATION
113
Selecting a Channel
Background
Each channel can be individually selected by using
its load module panel. Changing channels on a
load module only applies to dual channel load
modules.
Single Channel
Panel operation
Press any key on a load module to
select its channel.
Dual Channel
Panel Operation
For dual channel load modules,
press any key on a load module that
has the desired channel. Press the
R/L key to cycle between the
channels on the load module. L or R
will be displayed on the bottom left
hand to indicate which channel (left
or right side) is active on the load
module.
Note
On single channel modules, pressing the A/B key
repeatedly will change the level from A or B when in
Static mode.
To Next Page
Loading...
