PEL-2000 Series User Manual
56
Channel Control Connection
Background
The Channel Control connecters are located on the
rear panel of each mainframe. There are two
channel control connectors for each load slot, one
for each channel, if applicable. The channel control
connector is used to externally:
Turn on/off loads.
Supply a reference voltage.
Monitor the load input.
For further details on channel control and the
interface see pages 85, 235.
AWG 2 4
STRIP GAUGE
10.0 mm
1
CH CONT 1
1
CH CONT 2
1
CH CONT 3
1
CH CONT 4
1
CH CONT 5
1
CH CONT 6
1
CH CONT 7
1
CH CONT 8
SER. NO. LB
2
1
FRAME C ONT
GO / NG OUTPUT
GPIB
RS232C
DISCONNECT POWE R CORD
BEFORE REPLACIN G FUSE
50/60 Hz
180 V A MAX
AC
250V
T3.15A
REPLACEFUSE
115V
230V
FUSE RATING
AS SPECIFIED
WARNING
TO AVOID ELECTRIC SHOCK THE POWER CORD PROTECTIVE
DO NOT REMOVE CO VERS. REFER SERVICING TO QUALIFIED PERSONNEL.
250V FUSE OF THE SPECIFIED TYPE AND RATING.
FOR CONTINUED FIRE PROTECTION . R EPLAC E FU SE ON LY WI TH
NO OPERATOR SER VICEABLE COMPONENTS INSIDE.
GROUNDING CONDUCTO R MUST BE CONNECTED TO GROUND.
To Next Page
Loading...
