3. Use the Selector knob to move
the cursor down to Go-NoGo
Tone (below the initial screen).
4. Press the Selector knob to
highlight Go-NoGo Tone, then
turn to change to ON/OFF.
Adjusting Slave Knob Settings
Background
Channel loads can be edited using the local load
module or the Mainframe. When using the local
load module selector knob (slave knob) to edit a
load, the load module display can be set to two
different types: SetValue and Measured.
When a load is ON, SetValue will always display
the set value (A Value, B Value) on the local load
To Next Page
Loading...
