OPERATION
193
module display whilst “Measure” will show the
actual measured value when editing the load.
These settings apply to all channels.
The “Measure” setting can be temporarily disabled
by pressing the local load module selector knob to
display the “SetValue” instead of the “Measure”
value in the local load module display.
Parameter
Slave Knob Measure/SetValue
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
2. Press F5 (Other Menu).
03/02/09
10 : 30
ConfigureOther
System
Info
Load Interface Time Set
3. Use the Selector knob to move
the cursor down to Rotate Knob
(below the initial screen).
4. Press the Selector knob to
highlight Rotate Knob, then turn
to change to Measure/SetValue.
To Next Page
Loading...
