GW Instek PEL-2004 - Select CC Static Mode; Editing CC Static Parameters

PEL-2000 Series User Manual
126
Select CC Static Mode
Background
Constant current mode can be set to dynamic or
static mode. Static mode is for manually varying
the load for single channel load modules or to set a
static load on dual channel modules.
Ensure the menu is in CC Mode. See page 121.
Panel Operation
1. Press the F3 key until Static
mode is selected.
Note
Changing from static to dynamic mode will only affect
the current (active) channel.
Editing CC Static Parameters
CC Values
When using a single channel load module, Static
Constant Current Mode has two operating current
values A&B. If a dual channel load is used, only
one current value is available per channel:
A Value.
Ensure the menu is in CC Static Mode. See page 126.
Parameters
A Value 0~rating A
B Value
0~ratin
g
A
SlewRate
Load module dependen
t
SlewRate