GW Instek PEL-2004 - Select CC Range; Select CC Dynamic Mode

OPERATION
123
Select CC Range
Background
Constant current mode can run in high and low
range. Maximum range is dependent on the load
module.
Ensure the menu is in CC Mode. See page 122.
Panel Operation
1. Press the F2 (Range) key
repeatedly until High or Low
range is selected.
Range
High
Range
Low
Note
Changing the range will only affect the current (active)
channel. Other channels will not be affected by any
changes.
Note, not all load modules support dual ranges. If
only one range is supported, it is usually high range.
Select CC Dynamic Mode
Background
Constant current mode can be set to dynamic or
static mode. Dynamic mode is used to
automatically set varying load rates.
Ensure the menu is in CC Mode. See page 122.