PSU Series User Manual
38
Power Up
1. Connect the power cord to the
universal power input.
2. Press the POWER switch on.
3. The power supply will show the Power On
settings (Pon) at start up. If no Power On
settings are configured, the PSU will recover
the state right before the power was last turned
OFF. If used for the first time, the default
settings will appear on the display.
For default configuration settings, see page 194.
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
You may also configure how the PSU will behave on
startup by altering the Power On Configuration
settings, see page 109.
To turn the PSU power supply off, press the power
switch again (0 position). It may take a few
seconds for the power supply to fully turn off.
The power supply takes around 8 seconds to fully turn
on or shutdown.
Do not turn the power on and off quickly. Please wait
for the display to fully turn off.
To Next Page
Loading...
Need help?
General
