Protocol Settings 133
Haemonetics
®
Cell Saver
®
Elite
®
+ User Manual P/N 130859-US, Manual Revision: AA
Note: Quick Transfer must be enabled in Options before it can be displayed in
Settings. See “Making the Quick Transfer and Manual Mode Settings
Available” on page 136 for more information.
On: Allows Quick Transfer to be displayed on the Active Settings drop-
down list.
Off: Does not allow Quick Transfer to be displayed on the Active
Settings drop-down list.
Note: Quick Transfer is unavailable when the device is in Manual Mode.
Manual Mode (On/Off)
Determines if Manual Mode is available via the Active Settings drop-down list.
For more information, see “Manual Mode” on page 88.
Note: Manual Mode must be enabled in Options before it can be displayed in
Settings. See “Making the Quick Transfer and Manual Mode Settings
Available” on page 136 for more information.
On: Allows Manual Mode to be displayed on the Active Settings drop-
down list.
Off: Does not allow Manual Mode to be displayed on the Active Settings
drop-down list.
Note: Manual Mode is unavailable when the device is in Quick Transfer mode.
Final Cycle (On/Off)
Determines the End Procedure behavior, per the selected sub-settings below,
when air is detected during Fill.
On: The final cycle options are Last Partial Bowl Wash and End
Procedure. Only one of these options can be selected to manage the last
bowl.
Last Partial Bowl Wash:
Double: The device transitions to the Last Partial Bowl Wash
phase and automatically doubles the wash volume.
Single: The device transitions to the Last Partial Bowl Wash phase
using the normal wash volume.
Off: The device omits the Last Partial Bowl Wash.
End Procedure (On/Off)
Off: The only option is to end the procedure immediately.
To Next Page
Loading...
