Haemonetics Cell Saver Elite+ User Manual

32 Chapter 2
P/N 130859-US, Manual Revision: AA Haemonetics
®
Cell Saver
®
Elite
®
+ User Manual
Touch Screen
Cable Entry
The touch screen cable entry contains the cable that connects the device with
the touch screen.
Equipotential
Ground
Terminal
Connection
The equipotential ground terminal connection allows the user to connect the
Cell Saver Elite+ device to other devices/equipment in the area, bringing them
to the same potential.
Reservoir
Weigher
Connection
The reservoir weigher connection contains the cable that connects the device
with the reservoir weigher.
Power Entry
Module
The power entry module contains the power cord connection, ON/OFF switch,
and the main fuse holder.
Power Cord A power cord is supplied with the device. Inspect for a frayed or twisted power
cord. Do not replace the power cord with a substitute. If necessary, contact the
Haemonetics Customer Care Center for a replacement. Always ensure the
power cord is connected to an appropriately grounded power source.
Warning: Ground continuity can only be achieved when the equipment is
connected to a properly grounded outlet.
Note: The power cord can be coiled around the cart handle during transport or
when the device is not connected to a power source.

Haemonetics Cell Saver Elite+ Specifications

General

Power Supply	100-240 VAC, 50/60 Hz
User Interface	Touchscreen display
Automated Processing	Yes
Relative Humidity	20% to 80%, non-condensing
Data Management	Data logging and reporting
Anticoagulant	Citrate
Wash Volume	Adjustable
Bowl Size	125 mL, 225 mL
Processing Time	Typically 3-5 minutes per cycle
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Category	Intraoperative Blood Recovery System