26
Quick Start Guide
Q
uick Start GuideQuick Start Guide
Quick Start Guide
The Halcro Logic SSP180/220 is a
sophisticated product designed to be
compatible with the world’s leading analog
and digital audio/video components.
Due to the advanced nature of the
SSP180/220, there are many different user
configurations available and these can
become overwhelming if you are unfamiliar
with electronic component setup. Please
contact your dealer for installation and setup
guidance if you are unsure how to proceed.
Before you begin the initial
setup, make sure all
components are switched off
and unplugged at the mains.
This chapter provides a basic overview of the
connection requirements as well as basic
setup procedures. For more detailed setup
information, refer to the various setup
chapters in this manual.
Below are some basic notes to help you
during the installation and set up procedure:
• read the Important Safety Information on
page 4
• we recommend use of the UTSR1
Remote Control for menu setup
• charge your UTSR1 overnight ready for
use
• numbers shown in brackets throughout
this manual refer to the numbered
controls and connections shown on
page 14
• flow charts showing basic setup
procedures start on page 27
• use default source settings (page 29)
where possible
• use the connection diagrams (pages 32
to 37) to plug in connections for TV
monitor/ projector, amplifier and source
components
• the front panel menu does not have an
exit without save function
If you are unsure, use the UTSR1 to
access the menu and press ESC to exit
without saving changes. To save
changes select EXIT from each level until
the menu has been exited.
To Next Page
Loading...