6
Protection from overheating
Protection from overheatingProtection from overheating
Protection from overheating
The SSP180/220 generates a certain amount
of heat and requires ventilation. Slots and
ventilation holes are provided for ventilation
purposes, and to ensure reliable operation of
the product. To prevent fire hazards, these
openings must never be blocked or covered.
The SSP180/220 may be stacked on top of a
Halcro Logic MC20/30/50/70 amplifier but
overheating may result if ventilation is
inadequate. Ensure there is at least 4 in
(10 cm) above the uppermost unit for
ventilation.
Follow the precautions listed below. If these
precautions are not followed, overheating or
failure may result. Overheating also shortens
the working life of all components.
• do not block the ventilation holes in the
top or bottom of the unit with any object,
including paper, cloths or curtains
• do not place the unit on a soft surface
such as a rug, or carpet with a thick pile,
into which it could sink
• avoid placing the unit in a built-in
installation place such as a bookcase or a
rack unless you can provide proper
ventilation
• do not operate the unit inside a cabinet
unless it has adequate ventilation (such
as an open back panel)
• allow at least 4 in (10 cm) on all sides of
the unit (except the bottom
WARNING: Do not obstruct
ventilation slots in the chassis.
Additi
AdditiAdditi
Additional important safety
onal important safety onal important safety
onal important safety
instructions for the US
instructions for the USinstructions for the US
instructions for the US
The following instructions should be followed
by customers in the USA in addition to the
safety instructions in the rest of this chapter:
o Read these instructions.
o Keep these instructions.
o Heed all warnings.
o Follow all instructions.
o Do not use this apparatus near water.
o Clean only with dry cloth or according
to the cleaning instructions.
o Do not block any ventilation openings.
o Install in accordance with the
manufacturer’s instructions.
o Do not install near any heat sources
such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
o Do not defeat the safety purpose of
the polarized or grounding-type plug.
A polarized plug has two blades, with one
wider than the other. A grounding type
plug has two blades and a third
grounding prong. The wide blade or the
third prong is provided for your safety. If
the provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.
To Next Page
Loading...