73
Troubleshooting
T
roubleshootingTroubleshooting
Troubleshooting
Symptom
SymptomSymptom
Symptom
Rem
RemRem
Remedy
edyedy
edy
No sound Power cord is disconnected or power is OFF. Check if the Standby/On
LED (3) is illuminated.
An input is selected but no source is connected.
The source setup may be incorrect. Check the digital input connections
and digital input assignments in Source Setup – digital input.
The input selected has no signal (for example, because the tuner is not
on, or there is no disc in the CD player or the tape recorder has no tape
running). If the display indicates an incoming digital signal, check the
output connections. If the source is digital but the display indicates Analog,
check the digital input connections and digital Input setting in Source
Setup.
Faulty connections. Try connecting the source to other input connectors.
The internal fuse has blown. Contact your dealer or Halcro at
service@halcro.com
Sound missing in
one or more
channels
Interconnect cable defective: the interconnect cable is making poor
contact or not connected at all. Check and if necessary unplug and re-
plug the cable or cables.
Check speaker settings (size & level setup) in Speaker Setup.
Check mode settings as all speakers are not used in some modes.
Buzz or hum Interconnect cable defective or partially out of its socket.
Ground loop. Disconnect and re-connect one source at a time.
To Next Page
Loading...