74
Symptom
SymptomSymptom
Symptom
Remedy
RemedyRemedy
Remedy
Hum in tape playback The tape deck is too close to the power amplifier.
Plugs are making poor contact with sockets.
Sluggish response to
commands
Video source has a bad video signal.
No picture Power cord is disconnected or power is OFF.
Check if the Standby/On LED (3) is illuminated.
Faulty connections. Try connecting the source to other input connectors.
The internal fuse has blown. Contact your dealer or Halcro at
service@halcro.com
Check “Source Setup” for correct video source selection.
To Next Page
Loading...