Harris ADC Device Server User’s Guide
8-2 Requester Configuration
Requester Device Parameters
General Tab
Device Name
The name of the requester. The default is REQSTxx where xx is the position of the
requester within the server’s device list. This position is also known as the channel
number. You may change the device name to any name you wish. There is a 16 character
maximum.
Weighting
Weighting is used to t ell the requester to weight, by time, all requ ests. The requester adds
this time to an event’s projected on-air time and the result is the time that the media is
expected to be needed. Weighting allows some level of prioritization of requests from
different requesters on the same or different transmission lists.
Push Requester Parameters
Play Events: Off-air simulated (or “faked”) playing of the moved event. Used for
generating an As-run log entry.
Register Events When Moved: The requester not only removes the "REQUESTED" status,
but causes the list to turn the event BLUE after the operation. This provides an indicator to
the operator. If both Register Events When Moved and Play Events are enabled AND you
have used an available GMT list to load the push list into (as opposed to a standard
To Next Page
Loading...
General