Harris ADC Device Server User’s Guide
8-4 Requester Configuration
No Events Less Than (Mins)
Select a minimum number of minutes allowed for an event. Default is 0 minutes.
Only Record Events with ID in _ to _.
Select a range (minimum and maximum) for allowable IDs to be recorded. Any IDs that
fall outside the specified range will not be recorded.
Routing Tab
Routing Modes
Use this tab to define the potential delivery mode for material to a destination device.
Baseband: Real time video signal (either analog or digital). Baseband includes SDI and
SPIT modes. Default is enabled.
Fibre: JPEG or MPEG compressed data files. Fibre mode is typically used when both the
source and destination devices are video disks. Fibre transfers are typically non-realtime.
Default is disabled.
Archive: Usually a SCSI connection between the archive system and the video disk server.
This mode is used when the source device is a digital archive device (e.g., a StorageTek or
Ampex DST) under control of an Avalon Archive Manager. Default is disabled.
To Next Page
Loading...
General