Harris ADC Device Server User’s Guide
Requester Configuration 8-3
transmission list) then not only will each event turn BLUE, it will be marked PLAY and
then DONE (each event is run in a “fake” manner so that a DONE status appears and the
event is as-run logged).
Qualifiers Tab
Select the qualifications that this requester uses to determine if it should make requests for
media. Specify events with or without segments, events that run less than a specific
duration, and qualify events based upon the range of the ID. Usually you will need to set
the request qualifiers if you have multiple requesters on a transmission list, and these
requesters are requesting media from different sources.
Program - Spots
Events With Segments Only: Events must have segments in order to be recorded. Single
spots will not be recorded if this option is enabled. Default is disabled.
No Events With Segments: The opposite of the above option. Multi-segment IDs cannot be
recorded if this option is enabled. Default is disabled.
NOTE: If both of the above boxes are left at their default settings (both disabled), you can
record both single spot IDs and multi segment IDs.
No Events Greater Than (Mins)
Select a maximum number of minutes allowed for an event. Default is 5 minutes.
To Next Page
Loading...
General