Harris ADC Device Server User’s Guide
1 Installation
The ADC Device Server consists of a server and a client, each with communication
software that allows the server and client to “talk” to each other. The software on each
must be configured in order to communicate properly. See “Configuration Manager”
on page 2-1 for details on how to configure the server and client.
System Requirements
The following are the minimum requirements to run Harris’ ADC Device Server
software.
Microsoft Windows NT 4.0 with Service Pack 4 or later
100 MHz CPU (133 MHz recommended)
32 MB RAM (64 MB recommended)
CD-ROM drive
100 Mb compatible network card
Installing the NT Device Drivers
Insert the floppy disk or CD-ROM containing drivers for the Harris NT Device Server.
This disk/CD-ROM is labeled:
NT DRIVERS
VERSION 1.01
1. Run Windows Explorer, then double click on the setup.exe file on the floppy. If using
a CD-ROM, the CD is self-starting.
2. Proceed through the various screens, at the end of which you will be prompted to
restart the computer. Select Finish to restart the computer. Make certain the floppy is
still in the drive when you select Restart. Remove the floppy after the system finishes
rebooting.
3. After restarting, select Start > Programs > Administrative Tools > Event Viewer to verify
which Harris NT driver services have been started. You should see a service for
TimeCode, HarrisSer, HarrisGPI, and VREFSync.
To Next Page
Loading...
General