Harris ADC Device Server User’s Guide
Installation 1-9
7. The ADC Device Server only runs on the Harris 4-Port Serial Cards.
8. The SONY LMS object does not have the router built in anymore. Instead, a new device under
routers exits.
◆ Configure the LMS device first.
◆ Configure the LMS Router under Router/Switchers.
◆ Invoke the Properties form for the LMS Router and select the Cart Machine page.
Configure the LMS Router to use the correct cart machine. The Enable Switcher
Monitor only applies to Beta Carts that have the monitoring built in.
9. The Help > About Server menu on the Device Configuration and List Configuration screens
display the server name and version number of the server software. To display the version
number of the Configuration Manager, use the Help > About menu option (in the first screen of
the configuration program).
10. Sometimes if the NT Server generates a runtime error and you restart it, it may still be
running. If this appears to happen, invoke the Task Manager and see if a copy of
ADC100NT.EXE is already running. If it is, terminate that process before running
ADC100NT.EXE again.
11. There is no manual VTR mode in any of the Odetics cart machines under NT. The architecture
of these machines under NT prohibits this function.
12. The Standard Video Disk drivers and Profile drivers treat the two heads as one video stream
under NT. When assigning the STREAM to a list, both heads are moved as one pair. When
configuring Audio/Video this is also done on the STREAM so that you only have to configure
the STREAM once (but both heads will be automatically configured).
13. Some devices have not been ported to NT. These devices had been replaced in DOS with
newer device drivers. Only the newer device drivers are available under NT.
To Next Page
Loading...
General