Harris XL Series - 5.13.5 Set or Remove Priority 1 and Priority 2 Channels

14221-1850-2000, Rev. A
74
5.13.5 Set or Remove Priority 1 and Priority 2 Channels
Priority channels are scanned more often than non-priority channels. Note that P1 and P2 can only be set if
configured as “Keypad” and the scan list is not set to “Fixed” using RPM2.
To set or remove priority 1 and priority 2 channels:
1. Press the Menu button.
2. Navigate to the SCAN menu.
3. Highlight SCAN LISTS and press the Group/Channel Select Knob.
4. Scroll up or down to highlight the desired scan list and press the Group/Channel Select Knob.
5. Press the up or down navigation buttons to highlight the desired channel/group.
6. Press the OPTIONS soft key.
7. Highlight SET PRI1 or SET PRI2 and press the Group/Channel Select Knob. A Priority 1 channel
appears with a P1; a Priority 2 channel appears with a P2.
8. Select REMOVE PRI to remove priority.