14221-1850-2000, Rev. A
75
5.13.6 Custom Scan Lists
The Mixed Zone Scan (MZS) feature gives the user the capability to scan based on a custom scan list that
is assigned at the system level. The Custom Scan (CS) list can contain System and Channel/Group
configurations across P25 Trunked, P25 Conventional, and Analog Systems. When a Custom Scan List is
assigned to a P25T system, the radio can scan P25T, P25C and Analog systems. When assigned to a P25C
or Analog system, the radio only scans conventional channels. MZS also gives the user the capability to
scan beyond the selected system group set.
• P25T Scan
When a custom scan list is assigned to a P25T system, the user can scan P25T, P25C, and Analog
groups/channels. All P25T systems must have the same WACN, System ID, and Unit ID to be added
to the custom scan list. If P25C and/or analog channels are added to the custom scan list, the radio will
scan them using the Trunked/Conventional scan feature described in section 5.13.2, and will override
any other conventional scan list that may have been programmed using RPM2.
• P25C and Analog Scan
When a custom scan list is assigned to a P25C or Analog System, the user can scan P25C and Analog
channels. P25T systems are ignored.
Custom scan list can be created using RPM or at the radio. The radio supports up to ten (10) Custom Scan
lists, with up to 100 channels/groups in each.
5.13.6.1 Create Custom Scan List
To create a custom scan list at the radio:
1. Press the Menu button.
2. Navigate to the SCAN menu.
3. Highlight ASSIGNED CUSTOM LIST and press the Group/Channel Select Knob.
4. Press the OPTIONS softkey.
To Next Page
Loading...
Need help?
General
