Electrical connections, LEDs
24
a4643-1.0 HBM: public ClipX
Grounding
6.3 Available connections and LEDs
Fig. 8: Locations of the connections and LEDs; the connector designations X1
to X7 are imprinted on the housing; for meanings see table.
Important: You must ground the support rail on which you mount the
ClipX. If you want to mount the ClipX in a different way, such as on a
wall, you must ground the housing by way of the mount.
No. Description
1 X1: Ethernet port
2 X2: Power supply, Digital I/O, ClipX bus
3 X3: Analog output
4 X4: Transducer connection, TEDS
To Next Page
Loading...
