heat-timer ETV Platinum Plus - MOUNTING THE ETV PLATINUM PLUS

20
|
HEAT-TIMER CORP.
059305–00 REV. E
MOUNTING THE ETV PLATINUM PLUS MODULE MOUNTING
THE ENCLOSURE
1 Select an appropriate location to mount the ETV Platinum Plus module. The location must meet the following minimum
requirements:
• The mounting surface should be flat and strong enough to hold the weight of the device.
• The device can be mounted a maximum of 500 feet (152.4 meters) from the valve location, but should be mounted as near to
the valve as possible to avoid excessive wire runs.
• DO NOT mount the device in a location where it will be exposed to extreme heat, cold, humidity, or moisture.
2 Remove the Enclosure Wiring Cover (1) by removing the two lower screws (2) holding it to the base (3), and then remove the
Display Module (4) by removing the two middle screws (5) holding it to the base.
4
5
5
1
3
2
FIGURE 9
ETV PLATINUM PLUS MODULE ASSEMBLY
04 INSTALLATION INSTRUCTIONS