14 – 190 HEIDENHAIN Service Manual iTNC 530 HSCI
“Pinging" If no TNCremoNT connection is established, you can check by pinging, whether the ...
Ethernet card in the laptop
Ethernet card in the control
connection of both cards via Ethernet
... function properly.
"Ping-loopback-test" on the laptop (test of the Ethernet card of the laptop):
8 In the prompt enter the ping command followed a blank and the IP address of the Ethernet card of
the laptop (e.g. ping 160.1.178.23).
8 Confirm with ENTER . --> If the Ethernet card functions, it will respond!
If the Ethernet card does not function, a timeout message is displayed.
"Ping-loopback-test" on the control (test of the Ethernet card of the control):
8 Enter the code number NET123.
8 Press the DEFINE NET soft key. --> The window Network Settings opens.
8 Click the Ping/Routing tab.
8 Enter the IP address of the iTNC.
8 Click START. --> If the Ethernet card functions, it will respond.
Figure: "Ping-loopback test“ at the control successful
Pinging from the laptop to the control (test of the connection):
8 In the prompt enter the ping command followed by a blank and the IP address of the control.
8 Press ENTER to confirm. --> If the connection works, the control will respond.
If the connection does not work, a timeout message is displayed.
Figure: Pinging from the laptop to the control successful
To Next Page
Loading...
